Every homeowner’s worst dread is water damage. You might be picturing a freak flooding event brought on by a downpour or a mainline that bursts beneath the foundation, flooding every room with water.
Such accidents do take place. Water damage, though, need not be as severe, and it frequently isn’t. Your carpet may get significantly damaged to the point where you will need to tear it up and replace it due to little leaks from improperly installed pipes behind the walls, outdated architecture in an old apartment complex, and weather-related damage that develops over time.
Every time a house experiences water damage, the carpets don’t necessarily need to be completely replaced. Before it reaches that point, there are numerous interventions you can do.
This article will outline the information you need to be aware of if your carpet becomes water damaged, how to protect it, and how water damaged carpet repair Adelaide can help you at every stage.
Water Damage Restoration
- Drying out Carpets
If your carpet is wet, the first thing you need to do is dry it out properly. If your carpet is heavily soaked, then you should call a professional carpet cleaning service immediately. You can use a fan to blow hot air around the room, or you can even place a dehumidifier in the room to help dry things out.
- Cleaning Carpets
You can clean the carpets yourself if you want. However, you should make sure that you have the right tools to get the job done right. A good vacuum cleaner will work great for vacuuming the floor, while some people prefer using a steam mop instead.
- Deodorizing Carpets
Deodorizing carpets is not difficult at all. All you need is baking soda. After you have cleaned the area, sprinkle some baking soda over the carpet and let it sit for about 30 minutes. Then vacuum it up again. Repeat this process until the odour disappears completely.
A Step-By-Step Guide To Cleaning Water-Damaged Carpet
When water damage occurs, carpeting becomes wet, mouldy, and smelly. There are many methods of cleaning carpets after they have been affected by water damage. When choosing what method to use, consider how much time you want to spend cleaning the carpet, the cost of the services, and if you wish to get a professional opinion from water damaged carpet services before starting. If you choose to do the work yourself, here are some tips to keep in mind.
Step 1. Remove any furniture or items that may block access to the area where the problem occurred. Make sure you remove anything that could fall on top of the carpet and cause further damage.
Step 2. Use a clean mop and bucket to wash out the floor. A damp mop works best. Do not use hot water or steam. Hot water damages the fibres of the carpet. Steam burns the surface of the carpet and can lead to discoloration. After washing out the floor, wipe down the carpet using a dry mop.
Step 3. Vacuum the area thoroughly. Be careful when vacuuming electrical outlets or fixtures. Vacuum along the baseboard and under the cabinets.
Step 4. Dampen a towel and then place it over the entire carpet. Leave the towel in place overnight. In the morning, vacuum again, and then remove the towel. Wipe away the moisture that was left behind.
Step 5. Let the carpet air-dry completely. You can do this at home or take it to a local drying company.
Step 6. Once the carpet dries, apply a carpet protector or stain guard. These products protect the carpet from stains and help prevent the spread of mildew.
Step 7. Apply deodorizer to areas near the carpet that were exposed to moisture. Deodorizing helps eliminate unpleasant smells caused by mould, mildew, or urine.
Water’s Impact On Carpets
If water isn’t dealt with, it can ruin the carpet and lead to difficulties more serious than a slick sidewalk. Mould growth is the largest danger from carpet water damage in Adelaide. Once mould begins to spread, it can affect a building’s structural integrity and, more seriously, the health of the people who live there.
Mould can thrive in conditions where water has penetrated the carpet pad beneath the carpeting. Mould grows best in moist, dark environments and feeds on the carpet pad. It can be challenging to eliminate mould once it has begun to bloom in the rug padding and nearby regions.
The carpeting should be treated, and the source of the water problem should be addressed as soon as feasible.
Conclusion
It might be difficult to clean and save carpets that have been soaked. Reach out to Metro Carpet Repair Adelaide for cleaning and restoration services if you’ve had a water problem at your residence or place of business and are unable to resolve the issue on your own.